Omron R88D-KN01L-ECT-L User Manual page 314

9 Servo Parameter Objects
Speed for Motor Detection
3436 hex
Setting 10 to 20,000
range
Size 2 bytes (INT16)
• It outputs the Motor Speed Detection Output (TGON) when the motor speed reaches the set Speed
for Motor Detection (3436 hex).
• The setting has a hysteresis of 10 mm/s.
Speed [mm/s]
3436 hex + 10
3436 hex – 10
– (3436 hex – 10)
– (3436 hex + 10)
Motor Speed
Detection Output
Refer to 3-1-9 Control Output Details on page 3-12 for the Motor Speed Detection Output (TGON).
Brake Timing when Stopped
3437 hex
Setting 0 to 10,000
range
Size 2 bytes (INT16)
• Set the time required for the motor to be de-energized (servo free) after the Brake Interlock Output
(BKIR) turns OFF (i.e., brake held), when servo OFF status is entered while the motor is stopped.
• When the servo is turned OFF while the motor is stopped, the brake interlock output (BKIR) turns
ON, and the servo is de-energized after waiting for the set time (set value × ms).
Servo ON/OFF
Brake interlock
(BKIR)
Actual brake
Motor power
is supplied.
*1 Make the setting as follows to prevent the machine (workpiece) from moving or falling due to the delay time in
the brake operation (tb).
Brake timing when stopped (set value × 1 ms) ≥ tb
For the operation time, refer to 7-5 Brake Interlock on page 7-15.
9 - 38
mm/s
Unit
Access
OFF ON
ms
Unit
Access
1 to 6 ms
Hold
Released
*1
tb
Hold
Released
No power
Power
supply
supply
3437 hex
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
Default 1,000
setting
RW PDO map
Motor speed
OFF ON
Default
setting
RW PDO map
csv
Data A
attribute
Not possible
Time
A l l
0 Data B
attribute
Not possible