Omron R88D-KN01L-ECT-L User Manual page 575

Event name Servo Drive Overheat
Description The temperature of the Servo Drive radiator or power elements exceeded the specified value.
EtherCAT Master Function Module Source
Source
Error
Level
attributes
Effects User program
EtherNet/IP NET RUN
Indicators
System
-defined
variables
Assumed cause
The ambient temperature of the
Servo Drive exceeded the
specified value.
Cause and
Overload
correction
Attached None
information
Precautions/ "15" is displayed on the Servo Drive front panel and F015 is given as the AlarmCode (4001 hex).
Remarks
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
details
Minor fault
Recovery
Continues. Operation
–
Variable
None
Improve the ambient temperature
and the cooling conditions of the
Servo Drive.
Increase the capacities of the
Servo Drive and the motor. Or,
increase the setting of the
acceleration/deceleration time and
lighten the load.
Event code
Slave
Error reset
(after cycling slave
power)
Power drive circuit is OFF for relevant slave.
EtherNet/IP NET ERR
–
Data type
–
Correction
Appendices
34E1 0000 hex
Detection Continuously
timing
System
Log category
EtherNet/IP LINK/ACT
–
Name
–
Prevention
Check the ambient temperature of
the Servo Drive and set up the
necessary cooling conditions.
Increase the setting of the
acceleration/deceleration time
and lighten the load as much as
possible.
A - 129
A