Omron R88D-KN01L-ECT-L User Manual page 126

3 Specifications
Additional Information
If an Ethernet cable of Ethernet Category 5 (100BASE-TX) or higher is used, communications
will be possible even if the cable is not shielded. However, we recommend a cable with double,
aluminum tape and braided shielding to ensure sufficient noise immunity.
Recommended Connector (Modular Plug)
Use a shielded connector of Ethernet Category 5 (100BASE-TX) or higher.
Recommended connector is shown below.
Size x Number of cable
cores (pairs)
AWG24 x 4P
AWG22 x 2P
*1 It is recommended that you use this connector in combination with the Kuramo Electric Co. KETH-PSB-OMR
cable.
Precautions for Correct Use Precautions for Correct Use
When selecting a connector, confirm that is applicable to the cable that will be used. Confirm the
following items: Conductor size, conductor type (solid wire or twisted wire), number of twisted
pairs (2 or 4), outer diameter, etc.
Attaching the Connectors to the Cable
Use straight wiring for the communications cable, as shown below.
Pin No.
1
2
3
4
5
6
7
8
Connector hood
Note 1 Connect the cable shield to the connector hood at both ends of the cable.
2 There are two connection methods for Ethernet: T568A and T568B. The T568A connection method is
shown above, but the T568B connection method can also be used.
3 - 50
Recommended
manufacturer
Panduit Corporation
OMRON Corporation
Wire color
White-Green
Green
White-Orange
Blue
White-Blue
Orange
White-Brown
Brown
Shield
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
Model
MPS588 Panduit Corporation
Japan Branch Osaka Sales Office
*1 OMRON Corporation Customer
XS6G-T421-1
Support
Wire color
White-Green
Green
White-Orange
Blue
White-Blue
Orange
White-Brown
Brown
Shield
Contact
Pin No.
1
2
3
4
5
6
7
8
Connector hood