A-3-2 Error Description - Omron R88D-KN01L-ECT-L User Manual

A-3-2 Error Description
This section describes errors.
Controller Error Descriptions
Event name Gives the name of the error.
Description Gives a short description of the error.
Gives the source of the error.
Source
Error
Level
attributes
Effects User program
Gives the status of the built-in EtherNet/IP port and built-in EtherCAT port indicators. Indicator status is
Indicators
given only for errors in the EtherCAT Master Function Module and the EtherNet/IP Function Module.
System
-defined
Lists the variable names, data types, and meanings for system-defined variables that provide direct error
variables
notification, that are directly affected by the error, or that contain settings that cause the error.
Assumed cause
Cause and
correction
Lists the possible causes, remedies, and preventive measures for the error.
Attached Provides the additional information that is displayed by the Sysmac Studio or an NS-series PT.
information
Precautions/ Provides precautions, restrictions, and supplemental information.
Remarks
*1 One of the following:
Major fault: Major fault level
Partial fault: Partial fault level
Minor fault: Minor fault level
Observation
Information
*2 One of the following:
Automatic recovery: Normal status is restored automatically when the cause of the error is removed.
Error reset: Normal status is restored when the error is reset after the cause of the error is removed.
Cycle the power supply: Normal status is restored when the power supply to the Controller is turned OFF and then back
ON after the cause of the error is removed.
Controller reset: Normal status is restored when the Controller is reset after the cause of the error is removed.
Depends on cause: The recovery method depends on the cause of the error.
*3 One of the following:
System: System event log
Access: Access event log
*4 One of the following:
Continues: Execution of the user program will continue.
Stops: Execution of the user program stops.
Starts: Execution of the user program starts.
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
Source
details
Tells the
influence on
Recovery
*1
control.
Tells what will
happen to
Operation
execution of the
*4
user program.
Variable
Event code Gives the code of the error.
Gives details on the
Detection
source of the error.
timing
Gives the recovery
*2
Log category
method.
Provides special information on the operation that results
from the error.
Data type
Correction
Appendices
Tells when the
error is
detected.
Tells which log
the error is
*3
saved in.
Name
Prevention
A - 109
A