Omron R88D-KN01L-ECT-L User Manual page 547

Event
Event name
code
3847 0000 Interface
hex Input
Function
Number
Error 1
3848 0000 Interface
hex Input
Function
Number
Error 2
3849 0000 Interface
hex Output
Function
Number
Error 1
384A 0000 Interface
hex Output
Function
Number
Error 2
384B 0000 External
hex Latch Input
Allocation
Error
384C 0000 Overrun Limit
hex Error
384F 0000 Object Setting
hex Error 1
3850 0000 Object Setting
hex Error 2
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
Description
There is an undefined • There is an undefined
number specification number specification in the
in the input signal input signal (IN1, IN2, IN3,
(IN1, IN2, IN3, and and IN4) function
IN4) function allocations.
allocations. Or, a logic
• Different logic is set for the
setting error was
same function in the
detected.
function assignments of
the input signals (IN1, IN2,
IN3, and IN4).
There is an undefined • There is an undefined
number specification number specification in the
in the input signal input signal (IN5, IN6, IN7,
(IN5, IN6, IN7, and and IN8) function
IN8) function allocations.
allocations. Or, a logic
• Different logic is set for the
setting error was
same function in the
detected.
function assignments of
the input signals (IN5, IN6,
IN7, and IN8).
There is an undefined There is an undefined
number specification number specification in the
in the output signal output signal (OUTM1)
(OUTM1) function function allocation.
allocation.
There is an undefined There is an undefined
number specification number specification in the
in the output signal output signal (OUTM2)
(OUTM2) function function allocation.
allocation.
There is an error in the • The function was allocated
latch input function to input signals other than
allocation. IN5, IN6, or IN7.
• A latch input is assigned to
an NC signal.
• The same latch input is not
assigned to the same pin in
all Control Modes.
The motor exceeded • The gain or mass ratio is
the allowable not suitable.
operating range set in
• The set value of the
the Overrun Limit
Overrun Limit Setting
Setting (3514 hex)
(3514 hex) is too small.
with respect to the
position command
input range.
The electronic gear The electronic gear ratio
ratio exceeded the exceeded the allowable
allowable range. range.
External encoder ratio External encoder ratio
exceeded the exceeded the allowable
allowable range. range.
Assumed cause
Maj Prt
Appendices
Level
Reference
Min Obs Info
P.A-139
P.A-140
P.A-141
P.A-142
P.A-143
P.A-144
P.A-144
P.A-145
A - 101
A