Omron R88D-KN01L-ECT-L User Manual page 353

Normal Display (LED Display Selection (3700 hex) set to 0)
Main power supply turned
ON and EtherCAT
communications
established.
Servo ON
Error occurs
Error Display
The main error code flashes as a decimal
(example for an overload).
*1. " " will flash when a Safety Input Error (Error No. 30.0) occurs. "
EtherCAT Status Indicators
Check the status of the status indicators.
If the RUN indicator will not turn ON or the ERR indicator will not turn OFF, refer to 5-1-2 Status
Indicators on page 5-3 and check the status.
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
A
Main power supply interrupted and
EtherCAT communications not established.
Servo OFF
Error cleared
*1
[— —]
[— —] + Dot on right lights.
[00] + Dot on right lights.
Warning occurs
Warning Display
The hexadecimal warning code and the
normal display are displayed alternately
(example for an overload).
Warning code
(for 2 s)
" does not flash on the display.
10 Operation
Warning cleared
Normal code
(for approx. 4 s)
10 - 7
10