Configuring Automatic Updates - Brocade Communications Systems RFS6000 System Reference Manual

3

Configuring automatic updates

3. Refer to the following File Systems information.
4. Select CF, USB1 or USB2 and click the Format button (enabled only if the CF or USB are
Configuring automatic updates
Use the Automatic Updates screen to enable a facility that will poll a server address (you
designate) when the controller is booted. If updates are found since the last time the controller was
booted, the updated version is uploaded to the controller the next time the controller is booted.
Enable this option for either the firmware, configuration file or cluster configuration file. Brocade
recommends leaving this setting disabled if a review of a new file is required before it is
automatically uploaded by the controller.
To enable and configure the automatic update feature for controller firmware, configuration files
and cluster configurations:
74
Name Displays the memory locations available to the controller.
Available Displays the current status of the memory resource. By default, nvram and system
are always available.
•
•
Formatted This displays the format status of the memory devices. This ensures that the
external and internal memory device store the files securely. A formatted memory
device is less prone to crash and loss of data.
•
•
connected to the controller) to check if the memory device is formatted and available. You will
be prompted that proceeding will erase all data on the disk and if you would like to proceed.
A green check indicates the device is currently connected to the controller
and is available.
A red X indicates the device is currently not available.
A green check mark indicates the device is currently connected to the
controller and is available.
A red X indicates the device is currently not available.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01