Viewing Ping Statistics - Brocade Communications Systems RFS6000 System Reference Manual
Provides centralized wireless lan (wlan) configuration and management
Hide thumbs
Also See for RFS6000:
- Cli reference manual (839 pages) ,
- System reference manual (553 pages)
Table of Contents
Advertisement
4. Click OK to save and add the changes to the running configuration and close the dialog.
5. Refer to the Status field for the current state of the requests made from applet. This field
6. Click Cancel to return back to the Configuration tab without implementing changes.
Viewing ping statistics
Refer to the Statistics tab for an overview of the overall success of the ping test with the
destination IP addresses displayed within the screen. Use this information to determine whether
the destination IP represents a device offering the controller a viable connection to either extend
the controller's existing radio coverage area or provide support for additional Clients within an
existing network segment.
To view ping test statistics:
1. Select Diagnostics > Ping from the main menu.
2. Select the Statistics tab.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
Destination IP
Enter the IP address of the target device. This is the numeric (non DNS address)
destination for the device transmitted the ping packets.
No. of Probes
Define the number of ping packets transmitted to the target device. This value
represents the number of packets transmitted to the target IP address to discern
the round trip time between the controller and its connected device.
Timeout(sec)
Configure the timeout value (in seconds) used to timeout the ping test if a round
trip packet is not received from the target device. Ensure this interval is long
enough to account for network congestion between the controller and its target
device.
Frequency
Define the interval (in seconds) between ping packet transmissions. Define a
longer interval if high levels of network congestion are anticipated between the
controller and its target device. Use a value of 0 to execute a single ping test or
stop a currently running ping test.
displays error messages if something goes wrong in the transaction between the applet and
the controller
Configuring a ping
8
519
Advertisement
Table of Contents
