Enabling Global Settings For The Image Failover - Brocade Communications Systems RFS6000 System Reference Manual

3
Viewing controller firmware information
3. Select the checkbox to use this version on the next boot of the controller.
4. To edit the secondary image, select the secondary image, click the Edit button and select the
5. Refer to the Status field for the current state of the requests made from the applet. Requests
6. Click the OK button to commit the changes made and exit the screen.

Enabling global settings for the image failover

Use the Global Settings screen to specify a firmware version for use with the failover image.
1. Select an image from the table in the Firmware screen.
2. Click the Global Settings button.
3. Select the Enable Image Failover checkbox to load an alternative firmware version if the WLAN
4. Refer to the Status field for the current state of the requests made from the applet. Requests
5. Click OK to save and add the changes to the running configuration and close the dialog.
Updating the controller firmware
Use the Update screen to update the firmware version currently used by the controller.
NOTE
When performing a firmware update using the controller CLI, use the following syntax (specific to
FTP) ftp://username:password@ipaddress:port/path/filename.
If using TFTP, use tftp://ipaddress/path/filename.
66
Use this firmware on next reboot checkbox.
This firmware version will now be invoked after the next reboot of the controller.
are any "SET/GET" operation from the applet. The Status field displays error messages if
something goes wrong in the transaction between the applet and the controller.
module fails to load the selected version successfully after 2 reboot attempts.
are any "SET/GET" operation from the applet. The Status field displays error messages if
something goes wrong in the transaction between the applet and the controller.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01