Brocade Communications Systems RFS6000 System Reference Manual page 90

3
Configuring automatic updates
3. Refer to the Redundancy Configuration field to enable and define the configuration for
4. Refer to the Firmware field to enable and define the configuration for automatic firmware
5. Select the Start Update button to begin the file updates for the enabled controller
6. Click the Apply button to save the changes to the configuration.
7.
76
NOTE
In addition to the Protocols listed, on the Mobility RFS7000 Controller users can also
auto-update using USB or Compact Flash. On the Mobility RFS6000 Controller users can also
auto-update using USB.
automatic cluster file updates.
Enable Select the Enable checkbox to allow an automatic cluster file update when a new
(updated) file is detected (upon the boot of the controller) at the specified IP
address.
IP Address Define the IP address of the server where the cluster files reside. If a new version
is detected when the controller is booted it will be uploaded to the controller and
used upon the next boot of the controller.
User ID
Enter the User ID required to access the FTP or TFTP server.
File Name
Provide the complete and accurate path to the location of the cluster files on the
server. This path must be accurate to ensure the most recent file is retrieved.
(With Path)
Protocol Use the Protocol drop-down menu to specify the FTP, TFTP, HTTP, SFTP or resident
controller FLASH medium used for the file update from the server. FLASH is the
default setting.
Password
Enter the password required to access the server.
updates. If enabled, the located (updated) controller firmware is used with the controller the
next time the controller boots.
Enable
Select the Enable checkbox to allow an automatic firmware update when a new
(updated) version is detected (upon the boot of the controller) at the specified IP
address.
IP Address Define the IP address of the server where the firmware files reside. If a new version
is detected when the controller is booted it will be uploaded to the controller and
used upon the next boot of the controller.
User ID Enter the User ID required to access the FTP or TFTP server.
File Name Provide the complete and accurate path to the location of the firmware files on the
server. This path must be accurate to ensure the file is retrieved.
(With Path)
Protocol Use the Protocol drop-down menu to specify the FTP, TFTP, HTTP, SFTP or resident
controller FLASH medium used for the file update from the server. FLASH is the
default setting.
Password Enter the password required to access the server.
Version Provide the target firmware version to ensure the controller is upgrading to the
intended baseline.
configuration, cluster configuration or firmware facilities.
Click the Revert button to revert back to the last saved configuration.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01