Brocade Communications Systems RFS6000 System Reference Manual page 323

2. Select the Use Default Management Interface checkbox to use the controller's default
3. If wanting to use a local IP addresses (non controller management interface) for Clients
4. Use the Roam Interval to define maximum length of time Clients within selected WLAN are
5. Refer to the table of WLANs and select the checkboxes of those WLANs you wish to enable
6. Select the Enable Mobility checkbox to enable a Client to maintain the same Layer 3 address
7.
8. Select the All WLANs Off button to disable mobility for each WLAN listed.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
management interface IP address for Clients roaming amongst different Layer 3 subnets. The
IP address displayed to the right of the checkbox is used by Layer 3 Client traffic.
roaming amongst different Layer 3 subnets, select the Use this Local Address checkbox and
enter an IP address.
allowed to roam amongst different subnets.
Layer 3 mobility for.
Once the settings are applied, Clients within these WLANs can roam amongst different
subnets.
while roaming throughout a multi-VLAN network.
Select the All WLANs On button to enable mobility for each WLAN listed.
If unsure if you want to enable mobility for each WLAN, manually select just those you want to
enable.
5
Layer 3 mobility
309