Brocade Communications Systems RFS6000 System Reference Manual page 102

4
Viewing network IP information
3. The read-only IP Forwarding tab displays the current status between VLANs. To toggle the
88
status of routing between VLANs, use the Enable/Disable options located at the bottom of the
screen.
The following details display in the table:
Destination Subnet
Displays the mask used for destination subnet entries. The Subnet Mask is the IP
mask used to divide internet addresses into blocks (known as subnets). A value of
255.255.255.0 will support 256 IP addresses.
Subnet Mask Displays the mask used for destination subnet entries. The Subnet Mask is the IP
mask used to divide internet addresses into blocks (known as subnets). A value of
255.255.255.0 will support 256 IP addresses.
Gateway Address Displays the IP address of the Gateway used to route the packets to the specified
destination subnet. Do not set the gateway address to any VLAN interface used by
the controller.
Interface
Displays the interface name with which the destination subnet entries are
attached.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01