Related Manuals for Brocade Communications Systems RFS9510
Summary of Contents for Brocade Communications Systems RFS9510
- Page 1 53-1002918-01 ® 04 April 2014 Brocade Mobility RFS9510 Controller Installation Guide...
- Page 2 Export of technical data contained in this document may require an export license from the United States government. The authors and Brocade Communications Systems, Inc. assume no liability or responsibility to any person or entity with respect to the accuracy of this document or any loss, cost, liability, or damages arising from the information contained herein or the computer programs that accompany it.
-
Page 3: Table Of Contents
Hardware installation ........9 Installing the Mobility RFS9510 Controller ....10 Applying power to the controller . - Page 4 Waste Electrical and Electronic Equipment (WEEE) ... . . 23 TURKISH WEEE Statement of Compliance ....23 Brocade Mobility RFS9510 Controller Installation Guide 53-1002918-01...
-
Page 5: Introduction
Brocade Access Points intelligently handle the traffic flows, quality of service, mobility and security at remotely distributed locations, while the Mobility RFS9510 Controller provides a single point for configuration, policy setting, and remote troubleshooting. Hotspot configuration, security policy management, and statistics aggregation are all done by one powerful NoC controller. -
Page 6: Site Preparation
Verify cable lengths are within the maximum allowable distances for optimal signal transmission. Getting started This guide provides a pre-installation checklist and instructions for installing the Mobility RFS9510 Controller, accessing the Graphical User Interface (GUI), and performing initial configuration. Pre-installation checklist Location &... -
Page 7: Cautionary Statements
There are no user-serviceable components inside the Mobility RFS9510 Controller Opening the chassis will void the warranty. CAUTION BIOS settings on the Mobility RFS9510 Controller should not be changed. Changing any settings in the BIOS will void all warranty on the controller. CAUTION To prevent the controller from overheating, never install in an enclosed area not properly ventilated or cooled. -
Page 8: Safety Instructions For Rack Mount Installations
Contacting Brocade CAUTION The Mobility RFS9510 Controller uses a Class 1M laser module. Viewing the laser output with certain optical instruments designed for use at a distance (for example, telescopes and binoculars) may pose an eye hazard. Safety instructions for rack mount installations CAUTION A Mobility RFS9510 Controller requires a two man lift. -
Page 9: Customer Support Web Site
E-mail and telephone access Go to http://www.brocade.com/services-support/index.page for email and telephone contact information. Warranty coverage Contact Brocade Communications Systems using any of the methods listed above for information about the standard and extended warranties. Brocade Mobility RFS9510 Controller Installation Guide 53-1002918-01... - Page 10 Warranty coverage Brocade Mobility RFS9510 Controller Installation Guide 53-1002918-01...
-
Page 11: Specifications
Storage Humidity 5% to 85% RH (non-condensing) Operating Altitude Maximum 10,000 ft. @ 35° C (3048 m @ 95°F) Power specifications Input Voltage 100 to 240VAC, 50/60Hz, redundant power supply Input Power 750W (maximum) Brocade Mobility RFS9510 Controller Installation Guide 53-1002918-01... - Page 12 Electrical characteristics Brocade Mobility RFS9510 Controller Installation Guide 53-1002918-01...
-
Page 13: Hardware Installation
A UPS of the proper capacity for the data processing equipment must be purchased. Hardware installation The following sections describe the hardware installation for the Mobility RFS9510 Controller: CAUTION A Mobility RFS9510 Controller requires a two man lift. Use all appropriate cautions. Brocade Mobility RFS9510 Controller Installation Guide 53-1002918-01... -
Page 14: Installing The Mobility Rfs9510 Controller
Hardware installation Installing the Mobility RFS9510 Controller 1. Complete the instructions supplied with the rail kit to mount the Mobility RFS9510 Controller in an equipment rack. 2. Connect the power cords for both power supplies. 3. Connect the Ethernet cables, and connect the controller to the network. -
Page 15: Applying Power To The Controller
Keep the front bezel keys in a secure location only accessed by authorized personnel. Mobility RFS9510 Controller PCIe expansion and NIC cards The Mobility RFS9510 Controller supports two 10GBe Peripheral Component Interconnect Express (PCIe) cards and a hardware cryptography engine for superior encryption/decryption performance. -
Page 16: Power Supply Status Led
Power supply warning events where the power supply continues to operate (high temperature, high power, high current, slow fan speed) Green 1Hz Blink AC present, only 5 VSB on (PS off) Green Solid Output on and normal operation Brocade Mobility RFS9510 Controller Installation Guide 53-1002918-01... -
Page 17: Control Panel Leds
Control panel LEDs The control panel houses six LEDs indicating the controller’s operating state. The LEDs are visible when the front bezel is attached. Remove the front bezel to access the control panel. Brocade Mobility RFS9510 Controller Installation Guide 53-1002918-01... -
Page 18: Control Panel Buttons
Non-critical condition Hard drive Green Random blink Indicates normal disc activity activity System identity Blue Identify active system via command or button Control panel buttons The control panel assembly houses four control buttons. Brocade Mobility RFS9510 Controller Installation Guide 53-1002918-01... -
Page 19: Error Beep Codes
The error beep codes generated by the Baseboard Management Controller (BMC) are listed in the table below: Code Sequence Description 1-5-2-1 No CPUs installed or the first CPU socket is empty 1-5-4-2 Power Fault 1-5-4-4 Power control fault Brocade Mobility RFS9510 Controller Installation Guide 53-1002918-01... - Page 20 Hardware installation Brocade Mobility RFS9510 Controller Installation Guide 53-1002918-01...
-
Page 21: Controller Management Interface
1. Connect one end of an Ethernet cable to one of the ports on the back of the Mobility RFS9510 Controller, and connect the other end to a computer with a working Web browser. - Page 22 Using the Mobility RFS9510 controller management interface 6. Click Login. You are then prompted to change your password. Enter a new password, then enter it again to confirm it. 8. Click Apply. The password change is confirmed. Brocade Mobility RFS9510 Controller Installation Guide...
- Page 23 Using the Mobility RFS9510 controller management interface 9. Click OK. The Mobility RFS9510 Controller Dashboard is displayed. You have now established a connection to the Mobility RFS9510 Controller management interface. 10. For software configuration, please see the current System Reference Guide. The guide is available, at http://www.brocade.com/support/.
- Page 24 Using the Mobility RFS9510 controller management interface Brocade Mobility RFS9510 Controller Installation Guide 53-1002918-01...
-
Page 25: Regulatory Information
Regulatory Information This device is approved under the Brocade Communications, Inc. brand. NOTE All regulatory references to model RFS9510 are equivalent to MODEL: E2900 R2 as found on the hardware product label. This guide applies to the RFS9510 device. All Brocade devices are designed to be compliant with rules and regulations in locations they are sold and will be labeled as required. - Page 26 This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio interference may occur, in which case, the user may be required to take corrective actions. Brocade Mobility RFS9510 Controller Installation Guide 53-1002918-01...
- Page 27 Waste Electrical and Electronic Equipment (WEEE) Waste Electrical and Electronic Equipment (WEEE) For information on WEEE, please go to: http://www.brocade.com/company/corporate-responsibility/ corporate-citizenship/product-recycling/weee.page. TURKISH WEEE Statement of Compliance EEE Yönetmeliğine Uygundur Brocade Mobility RFS9510 Controller Installation Guide 53-1002918-01...