Brocade Communications Systems RFS6000 System Reference Manual page 203

4. Enter the device AP MAC Address (the physical MAC address of the radio). Ensure this address
5. Use the AP Type drop-down menu to define the radio type you would like to add. If adding a
6. From the Radio Settings section, select the radio type checkboxes corresponding to the type of
7.
8. Refer to the Status field for the current state of the requests made from applet. This field
9. If clustering is configured and the Cluster GUI feature is enabled the Apply to Cluster feature
10. Click OK to use the changes to the running configuration and close the dialog.
11. Click Cancel to close the dialog without committing updates to the running configuration.
Defining the AP radios mesh configuration
A separate mesh configuration can be set for each AP radio. Define mesh configurations as
required when dedicating an AP radio as either a base or client bridge within a mesh configuration.
To define the selected AP radio's mesh configuration:
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
is the actual hard-coded MAC address of the device.
Mobility 7131 model Access Point, the Access Point conversion will render the Access Point a
"thin" Access Point.
AP radio used. Available radio types are dependant on the AP Type selected above.
Enter a numerical value in the Radio Index field for each selected radio.
The Radio Index is a numerical value assigned to the radio as a unique identifier. For example:
1, 2, or 3. The index is helpful for differentiating radios of similar type and configuration.
displays error messages if something goes wrong in the transaction between the applet and
the controller.
will be available. Click the Apply to Cluster button to apply the AP radio settings to all members
in the cluster.
Viewing access point information
4
189