Brocade Communications Systems RFS6000 System Reference Manual page 127

8. Refer to the Advanced field for the following information:
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
Accounting Mode
If using a Syslog server to conduct accounting for the controller, select the Syslog
option from the Accounting Mode drop-down menu. Once selected, a Syslog Config
button is enabled on the bottom of the Network > Wireless LANs > Edit screen. Use
this sub screen to provide the Syslog Server IP address and port for the Syslog
Server performing the accounting function.
If either Hotspot, MAC Authentication or 802.1x EAP have been selected from
within the Authentication field, a Radius Config button is enabled (on the bottom of
the screen) allowing the user to define a Primary and Secondary Radius
Accounting Server IP address, port, shared secret password and timeout and retry.
Define these accounting settings as required for the controller.
The default Accounting Mode setting is Off.
Answer Broadcast ESS Select this checkbox to allow the WLAN to respond to probes for broadcast ESS.
Use Voice Prioritization
Select the Use Voice Prioritization option if Voice is used on the WLAN. This gives
priority to voice packets and voice management packets and is supported only on
certain legacy Brocade VOIP phones.
Enable SVP
Enabling SVP (Spectralink Voice Prioritization) allows the controller to identify and
prioritize traffic from Spectralink/Polycomm phones.
Secure Beacon
Closed system is the secure beacon feature for not answering broadcast SSID. This
option still allows Client to Client communication within the WLAN.
QoS Weight Sets the Quality of Service weight for the WLAN. WLAN QoS will be applied based
on the QoS weight value with the higher values given priority.The default value for
the weight is 1.
Client to Client Traffic Allows frames from one Client (where the destination MAC is of another Client) are
controllered to a second Client. Use the drop-down menu to select one of the
following options:
•
Drop Packets – This restricts Client to Client communication based on the
WLAN's configuration
•
Allow Packets – This allows Client to Client communication based on the
WLAN's configuration
Client Idle Time
Set the Clients idle time limit in seconds. The default value is 1800 seconds.
Access Category
Displays the Access Category for the intended traffic. The Access Categories are
the different WLAN-WMM options available to the radio.
The Access Category types are:
•
Automatic/WMM – Optimized for WMM
•
Voice – Optimized for voice traffic. Voice packets receive priority.
•
Video – Optimized for video traffic. Video packets receive priority.
•
Normal – Optimized for normal traffic
•
Low – Optimized for background traffic
MCast Addr 1
The address provided takes packets (where the first 4 bytes match the first 4 bytes
of the mask) and sends them immediately over the air instead of waiting for the
DTIM period. Any multicast/broadcast that does not match this mask will go out
only on DTIM Intervals.
Viewing and configuring controller WLANs
4
113