Brocade Communications Systems RFS6000 System Reference Manual page 236

4
Viewing Access Point adoption defaults
15. In the Max Roamed Clients for Voice Traffic field, specify the maximum number of voice Clients
16. In the Max Airtime for Voice field, specify a maximum percentage out of the radio's total airtime
17. In the Max Airtime for Reserved for Roaming field, specify a maximum percentage out of the
18. Refer to the Status field for the current state of the requests made from applet. This field
19. Click OK to use the changes to the running configuration and close the dialog.
20. Click Cancel to close the dialog without committing updates to the running configuration.
Configuring rate settings
Use the Rate Settings screen to define a set of basic and supported rates for the target radio. This
allows the radio to sync with networks using varying data rates and allows the radio to default to a
predefined set of data rates when higher data rates cannot be maintained.
To configure a radio's rate settings:
1. Click the Rate Settings button in the radio edit screen to launch a screen wherein rate settings
2. Check the boxes next to all Basic Rates you want supported by this radio.
3. Check the boxes next to all Supported Rates you want supported by this radio.
222
that are allowed to roam to this radio. Limiting the number of Clients can ensure that all voice
Clients receive enough bandwidth to ensure voice quality. Admission control is only available
for TSPEC enabled voice clients.
that may be used for voice.
radio's total airtime that may be used for voice Clients which roam from other APs.
displays error messages if something goes wrong in the transaction between the applet and
the controller.
can be defined for the radio.
Basic Rates are used for management frames, broadcast traffic and multicast frames. If a rate
is selected as a basic rate it is automatically selected as a supported rate.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01