Brocade Communications Systems RFS6000 System Reference Manual page 543

1. Go to Network > Access Point Radios and click on the Global Settings button.
2. Uncheck the Adopt Unconfigured Radios Automatically option to prevent the controller from
3. Configure the client bridge back haul WLAN, base bridge and client bridge radios on the
4. Configure Adaptive AP support on the Mobility RFS7000 Controller by adopting the AP's base
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
automatically adopting new APs when they are connected to the controller.
controller using the Command Line Interface (CLI) commands listed below.
Client Bridge Back Haul WLAN Configuration:
RFS7000(config-wireless)#wlan 1 enable
RFS7000(config-wireless)#wlan 1 ssid meshWlan
RFS7000(config-wireless)#wlan 1 independent
RFS7000(config-wireless)#wlan 1 client-bridge-backhaul enable
Base Bridge Radio Configuration: (Mobility 5181 that is wired to the
controller)
RFS7000(config-wireless)#radio add 1 "base bridge radio mac" 11bg aap5181
RFS7000(config-wireless)#radio add 2 "base bridge radio mac" 11a aap5181
RFS7000(config-wireless)#radio 1 base-bridge enable
RFS7000(config-wireless)#radio 1 bss 1 1
(map the mesh WLAN if manual mapping is enabled, not needed otherwise)
Client Bridge Radios Configuration: (Mobility 5181s that are wirelessly
connected)
RFS7000(config-wireless)#radio add 3 "client bridge radio mac" 11bg aap5181
RFS7000(config-wireless)#radio add 4 "client bridge radio mac" 11a aap5181
RFS7000(config-wireless)#radio 3 client-bridge enable
RFS7000(config-wireless)#radio 3 client-bridge ssid meshWlan
RFS7000(config-wireless)#radio 3 bss 1 1
(map the mesh WLAN if manual mapping is enabled, not needed otherwise)
bridge as well as client bridge. The client-bridge radios must be directly wired to the controller
during this configuration step.
Adaptive AP Overview
A
529