Brocade Communications Systems RFS6000 System Reference Manual page 507

To define the attributes of a new Radius Server:
1. Select Management Access > Users from the main menu tree.
2. Select the Authentication tab.
3. Click the Add button at the bottom of the screen.
4. Configure the following Radius Server attributes:
5. Refer to the Status field for the current state of the requests made from applet. This field
6. Click on OK to complete the addition of the Radius Server.
7.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
The Users screen displays.
Radius Server IP
Provide the IP address of the external Radius Server. Ensure this address is a valid
IP address and not a DNS name.
Address
Radius Server Port Enter the TCP/IP port number for the Radius Server. The port range available for
assignment is from 1 - 65535.
Number of retries to
Enter the maximum number of times for the controller to retransmit a Radius
communicate with Server frame before it times out the authentication session. The available range is
between 0 - 100.
Radius Server
Time to wait for Radius Enter the maximum number of times the controller can retransmit a Radius Server
Server to reply frame before it times out of the authentication session. The available range is
between 0 - 100.
Encryption key shared Enter the encryption key the controller and Radius Server share and must validate
with Radius Server before the user based authentication provided by the Radius Server can be
initiated.
displays error messages if something goes wrong in the transaction between the applet and
the controller.
Click Cancel to revert back to the last saved configuration without saving any of your changes.
Configuring Management Users
7
493