Brocade Communications Systems RFS6000 System Reference Manual page 181

3. Click the Details button to launch a screen with additional information about the selected
4. Highlight a Client from those listed and click the Disconnect button to remove the Client from
5. Click the Export button to export the content of the table to a Comma Separated Values file
6. Clicking the Edit MAC Name button will open a window where you can associate a name with
7.
Viewing client details
The Clients Details screen displays read-only Client transmit and receive statistics.
To view Client Details:
1. Select a Network > Wireless Clients from the main menu tree.
2. Click the Status tab.
3. Select a Client from the table in the Status screen and click the Details button.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
Ready
Displays whether the Client is ready for controller interoperation. Values are Yes
and No.
Session Timeout Displays the session timeout values for each of the listed Clients.
Power Save Displays the current (read-only) Power-Save-Poll (PSP) state of the Client. The
Power Save field has two potential settings. PSP indicates the Client is operating in
Power Save Protocol mode. In PSP, the Client runs enough power to check for
beacons and is otherwise inactive. CAM indicates the Client is continuously aware
of all radio traffic. CAM is recommended for Clients frequently transmitting with the
controller's Access Points for periods of two hours or greater.
WLAN
Displays the name of the WLAN the Client's associated AP is connect to.
VLAN
Displays the specific VLAN the target Client is mapped to.
Tunnel
Displays the tunnel the target Client is mapped to.
Radio Index
The Radio Index is a numerical device recognition identifier for Client radios. The
index is helpful to differentiate device radios when a particular Client has more
than one radio.
Radio Type The Radio Type defines the radio used by the adopted Client. The controller
supports 802.11a and 802.11g single radio Clients as well as dual radio
802.11ab, 802.11bg, 802.11an and 802.11bgn Clients.
Client. For more information, see
the list of currently associated devices.
Be aware that disconnected Clients will often become immediately re-connected to the
controller. Ensure disconnected Clients are permanently removed from controller association.
(CSV).
the selected Client's MAC Address. The MAC Name is a user created name used to identify
individual Client MAC Addresses with a user friendly name or description.
Clicking the dot11k button will open a new window where you can configure 802.11k Radio
Resource Management services.
Viewing associated client details
"Viewing client details" on page 167
4
167