Viewing Filtered Clients - Brocade Communications Systems RFS6000 System Reference Manual

6
Client intrusion detection
CAUTION
Setting Client threshold values too low can jeopardize Client performance or break the Client's
connection.
6. When using the Frames with known bad ESSIDs violation parameter it is necessary to enter a
7.
8. Click on Revert to rollback to the previous configuration.

Viewing filtered clients

Periodically check the Filtered Clients tab to review Clients filtered by the controller for incurring a
violation based on the settings defined within the Configuration tab. Each Client listed can be
deleted from the list or its attributes exported to a user defined location.
To view status of those Clients filtered using the settings defined within the Configuration tab:
1. Select Security > Wireless Client Intrusion Detection from the main tree menu.
2. Click on the Filtered Clients tab.
346
Threshold Values for
Set the radio threshold value for each violation type. If exceeded, the radio will be
filtered and displayed within the Filtered Radios screen.
Radio
Time to Filter Set the interval (in seconds) the controller uses to filter out Clients defined as
committing a violation. Refer to
contents of Clients filtered thus far.
NOTE
Setting a violation parameter to 0 will disable that option.
list of known bad ESSIDs for the violation parameter. To enter this information, select Frames
with known bad ESSIDs and then click the Bad Essid Config button to launch a dialogue box
where bad ESSIDs can be added and removed.
NOTE
If using the Frames with known bad ESSIDs violation parameter if no ESSIDs are entered in the
Bad Essid Config dialogue, this parameter will not function.
Click on Apply button to save the configuration.
"Viewing filtered clients"
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
on page 346 to review the
53-1001858-01