Brocade Communications Systems RFS6000 System Reference Manual page 549

1. Select System Configuration -> Adaptive AP Setup from the Access Point's menu tree.
df
2. Select the Auto Discovery Enable checkbox.
3. Enter up to 12 Controller IP Addresses constituting the target controllers available for AAP
4. If a numerical IP address is unknown, but you know a controller's fully qualified domain name
5. Select the Enable AP-Controller Tunnel option to allow AAP configuration data to reach a
6. If using IPSec as the tunnel resource, enter the IPSec Passkey to ensure IPSec connectivity.
7.
Adopting an Adaptive AP Using a Configuration File
To adopt an AAP using a configuration file:
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
Enabling auto discovery will allow the AAP to be detected by a controller once its connectivity
medium has been configured (by completing steps 3-6).
NOTE
Auto discovery must be enabled for a controller to detect an AP.
connection.
The AAP will begin establishing a connection with the first addresses in the list. If unsuccessful,
the AP will continue down the list (in order) until a connection is established.
(FQDN), enter the name as the Controller FQDN value.
controller using a secure VPN tunnel.
Click Apply to save the changes to the AAP setup.
NOTE
The manual AAP adoption described above can also be conducted using the Access Point's CLI
interface using the admin(system.aapsetup)> command.
Establishing Basic Adaptive AP Connectivity
A
535