Brocade Communications Systems RFS6000 System Reference Manual page 179
Provides centralized wireless lan (wlan) configuration and management
Hide thumbs
Also See for RFS6000:
- Cli reference manual (839 pages) ,
- System reference manual (553 pages)
Table of Contents
Advertisement
2. Configure the WLAN's NAC server settings.
3. Clients not NAC authenticated use Radius for authentication. To configure the WLAN's Radius
4. Configure the NAC server's timeout and re-transmit settings. The timeout parameter
5. Configure WLAN for EAP authentication and define the encryption type.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
RF Controller (config-wireless) #
a. Configure the NAC Server's IP address.
RF Controller(config-wireless) #wlan 1 nac-server primary 192.168.1.10
RF Controller(config-wireless) #
b. Configure the NAC Server's Radius Key.
RF Controller(config-wireless) #wlan 1 nac-server primary radius-key my-secret
RF Controller(config-wireless) #
NOTE
Configure the secondary NAC server for redundancy.
c.
Configure the secondary NAC server's IP address.
RF Controller(config-wireless) #wlan 1 nac-server secondary 192.168.1.20
RF Controller(config-wireless) #
d. Configure the secondary NAC Server's Radius Key.
RF Controller(config-wireless) #wlan 1 nac-server secondary radius-key my
secret-2
RF Controller(config-wireless) #
settings:
a. Configure the Radius server's IP address.
RF Controller(config-wireless) #wlan 1 radius-server primary 192.168.1.30
RF Controller(config-wireless) #
b. Configure the server's Radius Key
RF Controller(config-wireless) #wlan 1 radius-server primary radius-key
my-rad-secret
RF Controller(config-wireless )#
c.
Configure the secondary Radius server's IP address.
RF Controller(config-wireless) #wlan 1 radius-server secondary 192.168.1.40
RF Controller(config-wireless) #
d. Configure the secondary server's Radius Key.
RF Controller (config-wireless) #wlan 1 radius-server secondary radius-key
my-rad-secret-2
RF Controller (config-wireless) #
configures the duration for which the controller waits for a response from the Radius server
before attempting a retry. This is a global setting for both the primary and secondary server.
The re-transmit parameter defines the number of retries a controller attempts before
dis-associating the Client.
RF Controller(config-wireless) #wlan 1 nac-server timeout 30 retransmit 10
RF Controller(config-wireless) #
RF Controller(config-wireless) #wlan 1 authentication-type eap
RF Controller(config-wireless) #wlan 1 encryption-type wep128
Viewing and configuring controller WLANs
4
165
Advertisement
Table of Contents
