Viewing And Configuring Layer 2 Virtual Lans - Brocade Communications Systems RFS6000 System Reference Manual

3. Refer to the Address Resolution table for the following information:
4. Click the Clear button to remove the selected AP entry if no longer usable.

Viewing and configuring layer 2 virtual LANs

A virtual LAN (VLAN) is similar to a Local Area Network (LAN), however devices do not need to be
connected to the same segment physically. Devices operate as if connected to the same LAN, but
could be connected at different physical connections across the LAN segment. The VLAN can be
connected at various physical points but react as if it were connected directly. One of the biggest
advantages of a VLAN, is when a computer is physically moved to another location, it can stay on
the same VLAN without reconfiguration. The controller can support multiple VLANs. Use the Layer 2
Virtual LANs screen to view and configure VLANs by Port and Ports by VLAN information. Refer to
the following VLAN configuration activities:
•
•
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
Interface
Displays the name of the actual interface where the IP address
was found (typically a VLAN).
IP Address Displays the IP address being resolved.
MAC Address Displays the MAC address corresponding to the IP address being
resolved.
Type Defines whether the entry was added statically or created
dynamically in respect to network traffic. Entries are typically
static.
Viewing and Configuring VLANs by Port
Viewing and Configuring Ports by VLAN
Viewing and configuring layer 2 virtual LANs
4
91