Configuring Ekahau Parameters - Brocade Communications Systems RFS6000 System Reference Manual
Provides centralized wireless lan (wlan) configuration and management
Hide thumbs
Also See for RFS6000:
- Cli reference manual (839 pages) ,
- System reference manual (553 pages)
Table of Contents
Advertisement
5
Locationing
6. Click the Revert button to cancel any changes made within Multicast MAC Address value and
7.
8. To use the onboard SOLE engine to locate Aeroscout tags check the Enable checkbox. This is
9. If the onboard SOLE engine is enabled to locate Aeroscout tags, enter a Locate Interval in
10. Click the Apply button to save the Locate Interval value.
11. Click the Revert button to cancel any changes made within Locate Interval value and revert
If the onboard SOLE engine is enabled to locate Aeroscout tags the following information will be
displayed for each located Client:
Configuring Ekahau parameters
To configure the controller to work with an external Ekahau RTLS engine:
330
revert back to the last saved configuration.
If the Multicast MAC Address is configured and Aeroscout support is enabled the following
information will be displayed:
IP Address
Displays the IP address of the external Aeroscout RTLS engine.
Port
Displays the port number which the controller uses to connect to the external
Aeroscout RTLS engine.
enabled immediately after checking the box.
seconds to specify how often the known tags are located by the SOLE engine.
back to the last saved configuration.
MAC
Lists the MAC Addresses of all Clients which have been located by the controller.
Location:
Displays the value of the X Coordinate for each located Client. The X coordinate is
X Coordinate
relative to the origin point of 0,0 in the upper left corner of the site map.
Location:
Displays the value of the Y Coordinate for each located Client. The X coordinate is
relative to the origin point of 0,0 in the upper left corner of the site map.
Y Coordinate
Timestamp
Displays the last time for each Client that its location was computed by the
controller.
Zone
Lists the last known zone for each located Client. Zone configuration can be
defined using the CLI interface only. When no zones are configured, the controller
defaults the entire site to Zone 0.
NOTE
Zone configuration can be defined using the CLI interface only. For information on Zone
Configuration please see the Brocade RF Controller CLI Reference.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
Advertisement
Table of Contents
