Brocade Communications Systems RFS6000 System Reference Manual page 342

5
Locationing
4. Enter a value for the Client Locate Interval in seconds.
5. Click the Apply button to save the Client Locate Interval value.
6. Click the Revert button to cancel any changes made within Client Locate Interval value and
7.
Once SOLE has been enabled Clients found by the locationing engine will be displayed in the
Located Clients table at the bottom of the page. For each located Client the following information is
displayed:
328
The Client Locate Interval determines how often the locationing of Clients is updated. The valid
range for this is between 5 to 3600 seconds.
revert back to the last saved configuration.
NOTE
AP coordinates can only be configured in the Command Line Interface. For more information
on configuring AP coordinates please consult the Brocade RF Controller CLI Reference.
The Client MAC table allows you to manually add or remove MAC Addresses which can be
located by the SOLE engine. This supports a maximum of 512 Clients. This table is disabled
when the Locate All Clients checkbox is selected.
a. To add Clients to the Client MAC table click the Add button to open a dialogue box allowing
you to add a MAC Address to the Client MAC table allowing it to be located by the
controller's SOLE engine.
b. To remove a MAC Address from the Client MAC table select a MAC Address from the table
and click the Delete button to remove that Client. This table is disabled when the Locate
All Clients checkbox is selected.
MAC Lists the MAC Addresses of all Clients which have been located by the controller.
Location: Displays the value of the X Coordinate for each located Client. The X coordinate is
X Coordinate relative to the origin point of 0,0 in the upper left corner of the site map.
Location:
Displays the value of the Y Coordinate for each located Client. The Y coordinate is
relative to the origin point of 0,0 in the upper left corner of the site map.
Y Coordinate
Timestamp Displays the last time for each Client that its location was computed by the
controller.
Zone Lists the last known zone for each located Client. Zone configuration can be
defined using the CLI interface only. When no zones are configured, the controller
defaults the entire site to Zone 0.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01