Brocade Communications Systems RFS6000 System Reference Manual page 529
Provides centralized wireless lan (wlan) configuration and management
Hide thumbs
Also See for RFS6000:
- Cli reference manual (839 pages) ,
- System reference manual (553 pages)
Table of Contents
Advertisement
3. Select the Send log message to a file checkbox if you wish to store the log message.
4. Select the Use SNMP V2 only checkbox to use SNMP v2 to debug the applet.
5. Select the severity of the message you wish to store in the log file.
6. Select the message deployed when a bug is raised.
7.
8. Click the Revert button to revert back to the last saved configuration.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
The Applet Debugging field is partitioned into the following editable fields:
•
Send log message to a file.
•
Use SNMP v2 only.
•
Message Severity.
•
What kinds of message should be seen.
Enabling this checkbox allows you to select the file location where you wish to store the log
message.
Check whether you have access to SNMP v2 by clicking on the Test SNMP V2 access button. If
SNMP v2 access is available, the test icon will change from grey to green, indicating the
SNMPv2 interface is viable on the controller.
The Message Severity section allows you to report a bug and log it as per the following severity
levels:
•
Fatal - loss of data or controller functionality
•
Error - controller data compilation problem, could result in data loss
•
Warning - potential data loss of configuration corruption
•
Informational - data that may be useful in assessing a potential error
•
Debug - information relevant to troubleshooting
•
None - no impact.
The What Kind of message should be seen field allows you to select a range of parameters for
returned messages while debugging. Move your mouse pointer over a message checkbox for a
message description.
a. Click the Advanced button to display the entire list of message categories when bugs are
raised. Select the checkboxes corresponding to the message types you would like to
receive.
Each message category is enabled by default. Click the Simple button to minimize this area
and hide the available message categories.
b. Click the All Messages button to select all the message categories.
c.
Click the No Messages button if you do not want to select any of the message categories.
Click the Apply button to save the changes you have applied within this screen.
Debugging the applet
8
515
Advertisement
Table of Contents
