Configuring Wan Interface Cards - Brocade Communications Systems RFS6000 System Reference Manual

3. Check the Enable PoE checkbox to configure the selected port to use Power over Ethernet. To
4. Select the Priority level for PoE on this port. The Priority level is used in cases where the
5. Set the Power Limit (in watts) for this port's PoE usage. Setting the Power Limit places a cap on
6. Click OK to save and add the changes to the running configuration and close the dialog.

Configuring WAN interface cards

The Mobility RFS6000 controller supports 3G Wireless WAN cards using the ExpressCard slot. In
order to use a 3G Wireless WAN card with the controller it must first be activated on a laptop. For
activation information please consult the carier's activation instructions included with the card.
To configure a WAN Interface card:
1. Select Controller > Ports from the main menu tree.
2. Select the Wireless WAN Interface Card tab.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
disable PoE on a port, uncheck this box.
controller's PoE power consumption exceeds the available power. When this happens, ports
with higher Priority levels will be given precedence over those with a lower Priority level.
the maximum amount of power which can be drawn from the selected port.
NOTE
Power limits and power budgets are based on worst case operating conditions to deliver power
at the level requested. The worst case operating conditions assume the controller is operating
at its maximum operating temperature and at a maximum cable length. As a result power
levels may be between 5% and 10.5% over the requested level.
Viewing controller port information
3
57