Brocade Communications Systems RFS6000 System Reference Manual page 56
Provides centralized wireless lan (wlan) configuration and management
Hide thumbs
Also See for RFS6000:
- Cli reference manual (839 pages) ,
- System reference manual (553 pages)
Table of Contents
Advertisement
3
Viewing the controller interface
Apart from the sections mentioned above, it also displays the following status:
Redundancy State
Firmware
Management IP
Access Points
Wireless Clients
Up Time
1. Refer to the Alarms field for details of all the unacknowledged alarms generated during the
2. Refer to the Ports field for link, speed and duplex status of each physical port on the
42
Displays the Redundancy State of the controller. The status can be either Enabled
or Disabled.
Enabled - Defined a green state.
Disabled - Defined by a yellow state.
Displays the Firmware version of the current software running on the wireless
controller.
Displays the Management IP address of the controller.
Displays the total number of Access Points adopted by the controller.
Displays the total number of Clients associated with the controller.
Displays the actual controller uptime. The Uptime is the current operational time of
the device defined within the System Name field. Uptime is the cumulative time
since the controller was last rebooted or lost power.
past 48 hours. The alarms are classified as:
•
Critical — Denoted by a red indicator. These alarms warrant immediate attention.
•
Major — Denoted by a yellow indicator. These alarms warrant attention.
•
Others — Denoted by a blue indicator.
The alarms field also displays details (in a tabular format) of the 5 most recent
unacknowledged critical/major alarms raised during the past 48 hours. The table displays the
following details:
Severity
Displays the severity of the alarm. It can be either Critical or Major.
Last Occurrence
Displays the time when the alarm was reported.
Message
Displays the message associated with the alarm.
# Occurrences
Displays the number of times during the past 48 hours such an alarm was
generated.
controller's front panel. It displays the following details in a tabular format:
Name
Displays the name of the port (ge1-8, me1 or up1)
Status
Displays the status of the port, either— Up or Down
Speed
Displays the speed at which the port transmits or receives data.
Duplex
Displays the status of the port, either— Full Duplex or Unknown.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
Advertisement
Table of Contents
