Brocade Communications Systems RFS6000 System Reference Manual page 350

6
AP intrusion detection
3. Enable AP assisted scanning and timeout intervals as required.
4. Refer to the Client Assisted Scan field to enable associated Clients to assist in the detection of
336
Enable
Select the Enable checkbox to enable associated Access Points to detect
potentially hostile Access Points (the definition of which defined by you). Once
detected, the Access Points can be added to a list of APs either approved or denied
from interoperating within the controller managed network.
Approved AP timeout
Define a value (in seconds) the controller uses to timeout (previously approved)
Access Points that have not communicated with the controller. The range is from
1-65535 seconds, with a default of 300 seconds. This value is helpful for
continually re-validating Access Points that interoperate within the controller
managed network.
Unapproved AP timeout
Define a value (in seconds) the controller uses to remove Access Points that have
not communicated with the controller. The range is from 1-65535 seconds, with a
default of 300 seconds.
Access Points.
Enable
Select the Enable checkbox to enable associated Clients to detect potentially
hostile Access Points (the definition of which defined by you). Once detected, these
devices can be added to a list of Access Points either approved or denied from
interoperating within the controller managed network.
Refresh Time
Define a value (in seconds) associated Clients use to scan for Access Points. The
range is from 300 - 86400 seconds, with a default of 1800 seconds.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01