Brocade Communications Systems RFS6000 System Reference Manual page 384

6
Configuring firewalls and access control lists
Adding Layer 2 Firewall Configurations
To configure new Layer 2 firewall rules:
1. Select Security > Wireless Firewall from the main tree menu.
2. Click the Configuration tab.
3. Click the L2 tab.
4. Click the Add button.
5. Configure the following values for each new Layer 2 configuration:
370
Multicast Storm
Displays the Multicast Storm Threshold for each interface. When the rate of
multicast packets exceeds the high threshold configured for an interface, packets
Threshold
are throttled till the rate falls below the configured rate. Thresholds are configured
in terms of packets per second. The threshold range is 1-1000000 packets per
second.
Unknown Unicast Storm Displays the Unknown Unicast Storm Threshold for each interface. When the rate
of unknown unicast packets exceeds the high threshold configured for an
interface, packets are throttled till the rate falls below the configured rate.
Thresholds are configured in terms of packets per second. The threshold range is
1-1000000 packets per second.
Interface Name Assign the interface to be associated with the Layer 2 firewall. Available Layer 2
interfaces are ge 1-8 and up1.
ARP Rate
Specify the Address Resolution Protocol (ARP) rate. Rates can be between 1 and
1000000.
DHCP Trust Select to enable DHCP trust on this interface. A DHCP server must always be
connected to an interface that has its DHCP trust enabled.
ARP Trust
Select to enable ARP trust on this interface. ARP packets received on this interface
are considered trusted and information from these packets is used to identify
rogue devices.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01