Configuring Access Points - Brocade Communications Systems RFS6000 System Reference Manual

4

Configuring Access Points

7.
8. Refer to the Status field for the current state of the requests made from applet. This field
9. Click OK to use the changes to the running configuration and close the dialog.
10. Click Cancel to close the dialog without committing updates to the running configuration.
Configuring Access Points
Use the Access Point screen to view device hardware address and software version information for
adopted and unadopted Access Points. For more information, refer to the following Access Point
configuration sections:
•
•
•
•
•
•
•
Viewing adopted Access Points
Use the Adopted AP tab for gathering device hardware address and software version information
for the Access Point. Use this information to determine whether the Access Point's version supports
the optimal feature set available for the network.
To view existing adopted Access Point information:
1. Select Network > Access Point from the main menu tree.
2. Click the Adopted AP tab.
228
The CW Minimum is combined with the CW Maximum to make the Contention Window. From
this range, a random number is selected for the back off mechanism. Lower values are used
for higher priority traffic.
Enter a value between 0 and 15 for the Contention Window maximum value.
The CW Maximum is combined with the CW Minimum to make the Contention Window. From
this range, a random number is selected for the back off mechanism. Lower values are used
for higher priority traffic.
displays error messages if something goes wrong in the transaction between the applet and
the controller.
Viewing adopted Access Points
Viewing unadopted Access Points
Access Point configuration
Viewing sensor information
Configuring Secure WiSPe
Configuring Adaptive AP firmware
Configuring IP filtering
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01