Configuring Radio Groups For Client Load Balancing - Brocade Communications Systems RFS6000 System Reference Manual

4
Viewing access point information

Configuring radio groups for client load balancing

In order to do Client load balancing, radios must be grouped. Usually, two radios with similar
characteristics and geographically close to each other can be grouped together.
By default, a radio is not in any group and the load balancing algorithm would not apply to it.
To configure a group of radios together:
1. Select Network > Access Point Radios from the main menu tree.
2. Go to the Configuration tab.
3. Select a radio you wish to add to a group and click the Edit button.
4. Enter the Group ID for the group you wish to add the selected radio to.
5. Click OK to save the changes.
6. Repeat steps 3 through 5 for each radio you wish to add to groups.
7.
8. To verify the radio groups click on the Groups tab to view configured radio groups. For more
202
When you have finished adding radios to groups, click the Apply button on the Configuration
tab to save your changes.
information on viewing radio groups refer to "Viewing Access Point radio groups"
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
on page 203.
53-1001858-01