Brocade Communications Systems RFS6000 System Reference Manual page 129

4. Select the Dynamic Assignment checkbox for an user based VLAN assignment with Radius for
5. Select the Assign Multiple VLAN(s) button to map a WLAN to more than one VLAN. This displays
6. Configure the Multiple VLAN Mapping for WLAN table as required to add or remove multiple
7.
8. Select a row from the Multiple VLAN Mapping table and click the Remove button to delete the
9. Refer to the Status field for the current state of the requests made from applet. This field
10. Click OK to use the changes to the running configuration and close the dialog.
11. Click Cancel to close the dialog without committing updates to the running configuration.
Configuring authentication types
Refer to the following to configure the WLAN authentication options available on the controller:
•
•
•
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
this WLAN.
the Multiple VLAN Mapping screen.
VLANS for the selected WLAN.
Multiple VLAN's per WLAN are mapped (by default) to a regular VLAN and are not supported on
an adaptive AP. Refer to "Editing the WLAN configuration"
independent VLAN for adaptive AP support
VLAN
Displays the VLANs currently mapped to the WLAN. By default, VLAN 1 is
configured for any selected WLAN.
User Limit Displays the user limit configured for the mapped VLAN. The maximum allowed
user limit is 4096 per VLAN.
Select the Insert button to add the VLAN using the criteria described above.
mapping of a VLAN to a WLAN.
displays error messages if something goes wrong in the transaction between the applet and
the controller.
NOTE
In a cluster environment with multiple controllers, please ensure that the VLAN list is
consistent across all controllers.
Configuring 802.1x EAP
Configuring Kerberos
Configuring hotspots
Viewing and configuring controller WLANs
on page 109 to select and define an
4
115