Brocade Communications Systems RFS6000 System Reference Manual page 473

3. Select the Enable Enhanced Probe Table checkbox to allow an AP to forward Client probe
4. Define a Window Time (from 10 to 60 seconds) to set an interval used by the AP to record
5. Set a Maximum Numbers of Client's (from 0 to 512) to define the number of Clients configured
6. The Preferred Clients table lists the MAC Addresses for all preferred Clients.
7.
8. Click the Add button to open a dialogue and add the MAC Address of a preferred Client to the
9. 802.11a Mobility 300 Radios: Click the Enable all button to allow an AP's 802.11a radio to
10. 802.11bg Mobility 300 Radios: Click the Enable all button to allow the AP's 802.11bg radios to
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
requests to the controller.
Client probe requests. The Client radio probe entry with the highest signal strength during the
window period is recorded in the table.
in the controller table. The default is 50 Clients.
Select a Client from the Preferred Clients table and click the Delete button to remove the Client
from the table.
table.
receive Client probe requests and forward them to the controller. Click the Disable all button to
stop AP's 802.11a radios from forwarding Client probe requests to the controller.
receive Client probe requests and forward them to the controller. Click the Disable all button to
stop AP's 802.11bg radios from forwarding Client probe requests to the controller.
Configuring enhanced beacons and probes
6
459