Configuring The Role Based Firewall - Brocade Communications Systems RFS6000 System Reference Manual

6. Select an interface and click the Delete button to delete the interface configuration from the
7.
Adding a new ACL layer 2/layer 3 configuration
After creating an ACL, it can be applied to one or more interfaces. On a Layer 3 interface/ Layer 2
interface, ACLs can be applied only in an inbound direction. To add an ACL interface to the
controller:
1. Select Security > Wireless Firewall from the main menu tree.
2. Click the Security Policy tab.
3. Click the Attach-L2/L3 tab.
4. Click the Add button.
5. Use the Interface drop-down menu to select the interface to configure on the controller.
6. Use the IP ACL drop-down menu to select an IP ACL used as the inbound IP for the layer 2 or
7.
8. Refer to the Status field for the state of the requests made from applet. This field displays error
9. Click OK to use the changes to the running configuration and close the dialog.
10. Click Cancel to close the dialog without committing updates to the running configuration.

Configuring the role based firewall

Use the Attach Role screen to view and assign an ACL to a role.
To attach a role:
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
controller.
Click on Add button to add an physical or VLAN interface to the controller. For more
information, see "Adding a new ACL layer 2/layer 3 configuration"
Available options include – ge 1-8, up 1, VLAN 1 (plus those VLANs created thus far) and
Tunnel n (where n equals the name(s) of those tunnels created thus far).
layer 3 interface.
Use the MAC ACL drop-down menu to select an MAC ACL used as the MAC IP for the layer 2
interface.
messages if something goes wrong in the transaction between the applet and the controller.
Configuring firewalls and access control lists
6
on page 361.
361