Configuring Aeroscout parameters
To configure the controller to work with an external Aeroscout RTLS engine:
1. Services > RTLS from the main menu tree.
2. Select the Aeroscout tab.
3. Check the Enable checkbox to globally enable Aeroscout RTLS support on the controller.
4. Enter the Multicast MAC Address used for all Aeroscout tags to send updates via multicast to
5. Click the Apply button to save the Multicast MAC Address value.
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
53-1001858-01
NOTE
Zone configuration can be defined using the CLI interface only. For information on Zone
Configuration please see the Brocade RF Controller CLI Reference.
This takes effect immediately when the box is checked.
the MAC address specified. Typically the MAC address will start with 01-0C-CC-XX-XX-XX.
NOTE
To use the onboard SOLE engine to locate Aeroscout tags, site parameters, AP location
(Command Line Interface only) and Zone configuration (optional, Command Line Interface
only) must be configured.
5
Locationing
329