Brocade Communications Systems RFS6000 System Reference Manual page 340

5
Locationing
4. When mapping a site for locationing, an origin point must be selected in one of the corners of
5. Define the Dimensions used to define the site size:
6. The AP Information section displays the following information about APs:
7.
8. Click the Revert button to disregard any changes made within this screen and revert back to
Adding AP location information
To add AP Location information for your site
326
the site. That origin will become the upper left corner of the site map with coordinates of 0,0.
The length and width of the site is then mapped out on the X and Y axis (with length being X
and width being Y). Those length and width along with the height are entered into the field
below.
Length Enter the length of the site. This is the X axis of your site map based on the origin
point of 0,0. The size is either in feet or meters depending on which unit of
measure is selected below. The valid range for length is 1-3000m or 1-9000ft.
Width Enter the width of the site. This is the Y axis of your site map based on the origin
point of 0,0. The size is either in feet or meters depending on which unit of
measure is selected below. The valid range for width is 1-3000m or 1-9000ft.
Height Enter the height of the site. The size is either in feet or meters depending on which
unit of measure is selected below. The acceptable range for height is 0-60m or
0-180ft. Height is an optional parameter and is not taken into account by the
locationing algorithm.
Unit Use the drop-down menu to select the unit of measure used for dimensions. The
options are feet or meters.
AP MAC
Lists the MAC Addresses of all APs which have been configured for RTLS.
Location:
Displays the value of the X Coordinate for each AP. The X coordinate is relative to
the origin point of 0,0 in the upper left corner of the site map. This value is user
X Coordinate
configured and not detected by the controller. For information on how to configure
AP location information, see
Location:
Displays the value of the Y Coordinate for each AP. The Y coordinate is relative to
the origin point of 0,0 in the upper left corner of the site map. This value is user
Y Coordinate
configured and not detected by the controller. For information on how to configure
AP location information, see
Location:
Displays the value of the Z Coordinate for each AP. The Z coordinate is the height of
the AP relative to the lowest point of the site. This value is user configured and not
Z Coordinate
detected by the controller. For information on how to configure AP location
information, see
Status
Displays the status value for each AP.
Controller IP
Displays the IP address of controller associated with each AP configured for RTLS.
11a Radio
Displays the Index, MAC Address, Power and Channel information for the 802.11a
radio on each AP.
Click the Apply button to save the changes made within this screen. Clicking Apply overwrites
the previous configuration.
the last saved configuration.
"Adding AP location information"
"Adding AP location information"
"Adding AP location information"
Brocade Mobility RFS6000 and RFS7000 System Reference Guide
on page 326.
on page 326.
on page 326.
53-1001858-01