Configuring Ekahau Parameters - Brocade Communications Systems RFS6000 System Reference Manual

No. of TX Msgs Displays the number of messages transmitted by the switch to the external Aeroscout RTLS engine.
Last Msg TX Time Displays the Date and Time that the last message was sent to the external Aeroscout RTLS engine.
No. of Tag Reports Displays the number of Tag Reports received from the external Aeroscout RTLS engine.
8. To use the onboard SOLE engine to locate Aeroscout tags check the Enable checkbox. This is
9. If the onboard SOLE engine is enabled to locate Aeroscout tags, enter a Locate Interval in
10. Click the Apply button to save the Locate Interval value.
11. Click the Revert button to cancel any changes made within Locate Interval value and revert
If the onboard SOLE engine is enabled to locate Aeroscout tags the following information will be
displayed for each located client:
MAC Lists the MAC Addresses of all Clients which have been located by the switch.
Location: Displays the value of the X Coordinate for each located client. The X coordinate is relative to the origin point of 0,0 in
X Coordinate the upper left corner of the site map.
Location: Displays the value of the Y Coordinate for each located client. The X coordinate is relative to the origin point of 0,0 in
Y Coordinate the upper left corner of the site map.
Timestamp Displays the last time for each client that its location was computed by the switch.
Zone Lists the last known zone for each located client. Zone configuration can be defined using the CLI interface only.
When no zones are configured, the switch defaults the entire site to Zone 0.
NOTE
Zone configuration can be defined using the CLI interface only. For information on Zone
Configuration please see the Brocade RF Switch CLI Reference.

Configuring Ekahau Parameters

To configure the switch to work with an external Ekahau RTLS engine:
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01
enabled immediately after checking the box.
seconds to specify how often the known tags are located by the SOLE engine.
back to the last saved configuration.
5
327