Toshiba e-STUDIO206L Service Manual page 1174

Sub
05/08 Mode Element
element
08 Setting Printer Process Conditions at the
mode occurrence of fuser
related error
08 Setting Printer General
mode
08 Setting Printer General
mode
08 Setting Printer Feeding Bypass paper size
mode system/Pa detection setting
per
transport
08 Setting Printer Feeding Bypass paper size
mode system/Pa detection counter
per
transport
08 Setting Printer General
mode
08 Setting Printer Counter
mode
08 Setting Printer Feeding
mode system/Pa
per
transport
08 Setting Printer Finisher
mode
e-STUDIO206L/256/306/356/456/506
Item Subitem Code
4570
4581
4582
4621
4622
4675
4676
4691
4695
Sub- Default Acceptable
Details
code value value
5 Error counter 0 0-255
SRAM Backup -
SRAM copy -
PPC/PRT 0 0~1
PPC/PRT 0 0~65535
Paper ejection setting 2
for wrong bypass
paper size
Ejection counter for 0 0~65535
wrong bypass paper
size
Switching of the 1 0~1
display of jam location
in the drawer when
paper feed jam
occurs
Synchronous writing -
of the finisher
adjustment value
42
RAM Contents
M 1-3: Fusing error when warm-up-40-degrees C
detected
4-10: Fusing error when warm-up-100-degrees C
detected
11-25: Fusing error when ready from warm-up
50-55: Fusing error at ready
100-111: Fusing error at printing
150-153: Fusing error in the prewarming/JAM/cover
open/adjustment mode
- - The data in the SRAM is backed up in the EEPROM.
- - The data in the EEPROM is copied to the SRAM.
M Detects whether the size of paper fed by bypass
feeding is the same as the paper size set on the control
panel. If the sizes are not the same, the warning
message is displayed (Paper jam does not occur).
When the bypass paper size detection is broken, the
equipment can be used without the size detection by
disabling this setting. After repair, enable this setting.
0: Enabled 1: Disabled
M This is a counter for bypass paper size detection
setting. If the printing is executed with the paper size
that differs from the paper size set on the control panel,
the counter is counted up.
0-2 M 0 and 1: Disabled
2: Ejected
M Number of ejection times
M 0: Disabled
1: Enabled
- M Writes the adjustment code from 05-4819 to 4827 in
the SRAM of the finisher. (for MJ-1032 and MJ-1033)
Proc Service
edure UI
4
3
3
1
1
1
1
1
3