Toshiba e-STUDIO206L Service Manual page 1175

Sub
05/08 Mode Element
element
08 Setting Printer Finisher
mode
08 Setting Process Process
mode
08 Setting Process Process
mode
08 Setting Process Process
mode
e-STUDIO206L/256/306/356/456/506
Item Subitem Code
4696
5001
5001
5001
Sub- Default Acceptable
Details
code value value
Synchronous reading -
of the finisher
adjustment value
0 Print job end cleaning 0 0~9
bias polarity switching
frequency
1 Print job end cleaning 3 0~9
bias polarity switching
frequency (Bypass
non-standard)
2 Print job end cleaning 3 0~9
bias polarity switching
frequency (Mass
printing of small size
paper)
43
RAM Contents
- M Reads the adjustment code from 05-4819 to 4827 from
the SRAM of the finisher. (for MJ-1032 and MJ-1033)
M In the cleaning operation of the transfer roller at the end
of printing, the cleaning bias, in which the polarity is
switched from positive to negative, is output so that the
toner adhering to the transfer roller is returned to the
photoconductive drum. This code is used to set the
cleaning bias switching frequency. Perform adjustment
when there is any stain on the back side of the printed
paper (leading edge) caused by the transfer roller. Note
that the drum driving time will increase if the setting
value of the cleaning bias switching frequency is too
large. The setting code differs depending on the
operation status of the equipment when there is any
stain on the back side of the printed paper. Select the
code from 5001 to 5003 according to the operation
status. Set this code when there is any stain on the
back side of the printed paper (leading edge) caused by
the transfer roller in normal printing.
0: Once 1: Twice 2: Three times 3: Four times 4: Five
times 5: Six times 6: Seven times 7: Eight times 8: Nine
times 9: Ten times
M Set this code when there is any stain on the back side
of the printed paper (leading edge) caused by the
transfer roller in printing non-standard paper from the
bypass tray.
0: Once 1: Twice 2: Three times 3: Four times 4: Five
times 5: Six times 6: Seven times 7: Eight times 8: Nine
times 9: Ten times
M Set this code when there is any stain on the back side
of the printed paper (leading edge) caused by the
transfer roller in printing maximum size paper after
printing a large amount of small size paper (1 to 9).
0: Once 1: Twice 2: Three times 3: Four times 4: Five
times 5: Six times 6: Seven times 7: Eight times 8: Nine
times 9: Ten times
Proc Service
edure UI
3
4
4
4