Cautions When Data Overwrite Kit (Gp-1060) Is Installed - Toshiba e-STUDIO281c Service Handbook

(9) Install the FAX board taken off in step (1).
* If the FAX board has not been installed, the following steps are not necessary.
(10) Start up with the Setting Mode (08).
(11) Set the destination with 08-701 (Destination setting of FAX machine).
(12) Start up with the FAX Clearing Mode (1*).
(13) Perform 1*-100 (FAX Set Up).
(14) Turn the power OFF.
(15) Turn the power ON.
(16) Set the dial type. [USER FUNCTIONS] → [ADMIN] → [FAX] → [INITIAL SETUP]
5.3.5

Cautions when Data overwrite kit (GP-1060) is installed

When the Data overwrite kit (GP-1060) is installed, follow the cautions below.
<<Cautions when disposing of the HDD>>
Before disposing of the HDD of the equipment, be sure to perform 08-1426 (forcible HDD data clearing)
and confirm that deleting of the HDD data is completed.
• Check that the percentage is 100% and "HDD Erase [OK]" appears on the upper left of the screen.
• Check that the version (SYS V1.0) is displayed on the lower right of the screen.
* When the scrambler board is installed, data in the HDD are overwritten with encrypted data and
erased.
<<Caution when disposing of the SYS board>>
Before the SYS board is disposed, the following codes can be performed.
• 08-1427 (Forcible NVRAM data all clearing)
• 08-1428 (Forcible SRAM backup data all clearing)
If these codes are performed, the equipment cannot be started up.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
5 - 149
05/11
e-STUDIO281c/351c/451c
TROUBLESHOOTING
5