Command
EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.2(0.2)
9.0.2.0
8.3.19.0
8.3.12.0
6.3.1.0
debug isis snp-packets
To debug IS-IS complete sequence number PDU (CSNP) and partial sequence number PDU (PSNP)
packets, enable debugging on a specific interface and provides diagnostic information.
Z9500
Syntax
debug isis [vrf vrf-name] snp-packets [interface]
To turn off debugging, use the no debug isis [vrf vrf-name] snp-
packets [interface] command.
Parameters
vrf vrf-name
interface
1032
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a port channel interface, enter the keywords port-
channel then a number.
•
For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Description
Added support for VRF. Introduced on the S6000-ON.
Introduced on the Z9000.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced.
(Optional) Enter the keyword vrf followed by the name of the
VRF to enable debugging information on ISIS for CSNP/PSNP
packets tied to that VRF. The command displays the SNP
(CSNP/PSNP) related debugging information.
(OPTIONAL) Identifies the interface type slot/port as one of
the following:
Intermediate System to Intermediate System (IS-IS)