Module-5; Monitor Messages - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

MONITOR Messages

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Error Message
Error Message
MODULE-6
Error Message
Error Message
MONITOR Messages
This section contains the MONITOR messages.
MONITOR-6
Error Message
Cisco NX-OS System Messages Reference
2-392
MODULE-5-STANDBY_SUP_OK: Supervisor [dec] is standby
Module [decimal digit] is ready to be configured and be able to switch traffic.
Explanation
No action is required.
Recommended Action
MODULE-5-XBAR_OK: Xbar [dec] is online (serial: [chars])
Explanation Xbar [decimal digit] is ready to be configured and be able to switch traffic.
No action is required.
Recommended Action
MODULE-5-XBAR_REINIT: Re-initializing xbar [dec] (serial: [chars])
Explanation Xbar [decimal digit] reported a failure during the initialization phase and will be
rebooted.
Collect information about the module by issuing the commands 'show
Recommended Action
module_internal all xbar <module number>'.
MODULE-6-MOD_PURGE_CONFIG: Purging the configuration for module [dec]
Notification is being sent to remove the module configurations.
Explanation
No action is required.
Recommended Action
MODULE-6-MOD_REG_OK: Registration succeeded for module [dec]
Module [decimal digit] sent a successful registration message.
Explanation
Recommended Action No action is required.
MONITOR-6-ETH_SPAN_SESSION_CREATED: Session [dec] created
A new span session has been created.
Explanation
Recommended Action No action is required.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03