Span-2; Span-3; Span-5 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
from session [[dec]].
Error Message
corruption
Error Message
Error Message
active sup was restarted stateless.
SPAN-6
Error Message
Error Message
[chars]
OL-15994-03
SPAN-5-SPAN_CFG_REJECT_VSAN_SRC_PRESENT: Source VSAN [[dec]] removed
Explanation Source VSANs are removed from the session as mixing of interface and VSANs is not
supported.
No action is required.
Recommended Action
SPAN-5-SPAN_PSS_CORRUPTION: Span is starting stateless due to PSS
Explanation Due to unrecoverable PSS corruption error, SPAN starts stateless without any
configuration.
No action is required.
Recommended Action
SPAN-5-STATELESS_RESTART: Span is restarting stateless.
Explanation Due to unrecoverable error, Span is starting stateless. The currently active sessions will
not be preserved. The user will have to reenter all of the configuration.
No action is required.
Recommended Action
SPAN-5-STATELESS_RESTART_ON_ACTIVE: Span is restarting as Span on
Explanation Due to unrecoverable error, Span on active supervisor was restarted stateless. So, the
standby Span restarts to get in synchronizationwith the stateless Span on active.
No action is required.
Recommended Action
SPAN-6-SESSION_DOWN: Session [dec] is inactive ([chars])
Session [dec] is inactive now. Traffic for this session is no longer spanned.
Explanation
Check the reason for session inactive using the command 'show span session'
Recommended Action
and take corresponding action.
SPAN-6-SESSION_UP: Session [dec] is active, destination SD port
Explanation Session [dec] is active now. You can monitor Spanned traffic at the destination SD port.
No action is required.
Recommended Action
Cisco NX-OS System Messages Reference
SPAN Messages
2-617