U6Rib Messages - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
U6RIB-2
Error Message
%s, create: %s
Error Message
Error Message
Error Message
%s()
Error Message
OL-15994-03
U6RIB-2-API_INIT_SEM Format: Failed to init the API semaphore: open:
U6RIB could not create the semaphore that protects access to the shared memory
Explanation
between U6RIB and its clients.
Parameters: Error from open, Error from create ...
Use 'reload' command to reload the system. Be aware that this problem affects
Recommended Action
all VDCs on the system.
U6RIB-2-NOPMEM Format: Failed to allocate private memory for %s
U6RIB has run out of private memory. This condition can be caused by a temporary
Explanation
increase in the number of routes in the network, or a general network or router misconfiguration.
Configure the network or router to decrease the number of routes, or add
Recommended Action
additional memory to the router.
U6RIB-2-NOSMEM Format: Failed to allocate shared memory for %s
Explanation U6RIB has run out of shared memory to store routes. This can be caused by a temporary
increase of the number of routes in the network, or a general network or router misconfiguration.
Recommended Action Configure the network or router to decrease the number of routes, or
reconfigure the shared memory through the following vdc mode commands: limit-resource
u4route-mem min <min> max <max> limit-resource u6route-mem min <min> max <max>.
U6RIB-2-RES_MGR Format: Error returned from %s, errno: 0x%08x (%s) in
The resource manager returned an error to U6RIB, while U6RIB was performing an
Explanation
action relating to its shared memory
Parameters: RM Function, Error Code, Error Description, Calling Function ...
Use 'reload' command to reload the system. Be aware that this problem affects
Recommended Action
all VDCs on the system.
U6RIB-2-STARTUP_FAILURE Format: Startup failure: %s
An unrecoverable software error has occurred during u6RIB startup.
Explanation
Use 'reload' command to reload the system. Be aware that this problem affects
Recommended Action
all VDCs on the system.
Cisco NX-OS System Messages Reference

U6RIB Messages

2-749