Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 684

SVC Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
) Internal error - waitpid failed [chars]
Explanation
to this error.
Recommended Action
re-install the code on the node. The node will then have to be removed and re-added back to the
cluster. 3. Ensure that the software is at the latest level on the cluster. If not, upgrade the cluster and
if necessary repeat step 2 with the latest level of code. 4. If the error continues, ask IBM Product
Support for assistance.
Error Message
SS_EID_EC_ER_WARMSTART_MEMORY_FAILED ) Internal error - warmstart memory device
[chars]
Explanation
this error.
Recommended Action
node will then have to be removed and re-added back to the cluster. 2. Ensure that the software is at
the latest level on the cluster. If not, upgrade the cluster and if necessary repeat step 1 with the latest
level of code. 3. If the error continues, ask IBM Product Support for assistance.
Error Message
SS_EID_FC_ER_MAPPING_STOPPED ) FlashCopy has been stopped [chars]
Explanation
copy may affect the status of other VDisks in the same I/O group. Preparing the stopped flash copies
as soon as possible is advised.
Recommended Action
again. 2. Mark the error you have just repaired as fixed.
Error Message
) FlashCopy prepare failed due to cache flush failure [chars]
Explanation
Recommended Action
you have just repaired as fixed.
Error Message
) Flash Copy Stopped [chars]
Explanation
result of a user request to stop.
Recommended Action
Support web site http://www.cisco.com/tac.
Cisco NX-OS System Messages Reference
2-646
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec] SS_EID_EC_ER_WAITPID_FAILED
The process was unable to launch the IO program properly. Node was warmstarted due
If this error is repeated continously, 1. Reload the node. 2. If the error persists,
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
The process was unable to warmstart the memory device. \ Node was rebooted due to
If this error is repeated continously, 1. Re-install the code on the node. The
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
A Flash Copy mapping task has been stopped because of an error. \ A stopped flash
1. Correct higher priority errors. Then, prepare and start the Flash Copy task
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec] SS_EID_FC_ER_PREPARE_FAILED
A Flash Copy prepare task has failed because a cache flush has failed.
1. Correct higher priority errors, then retry the prepare tasks. 2. Mark the error
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec] SS_EID_FC_ER_STOP_COMPLETED
The Flash Copy mapping or consistency group has entered the STOPPED state as a
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Chapter 2 System Messages and Recovery Procedures
OL-15994-03