Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 864

XBAR Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
%i
Explanation
to reboot. If you have two supervisor modules, a switchover will occur.
Recommended Action
Error Message
to check sync on port [dec] return_code [hex] ([chars]).
Explanation
Recommended Action
Error Message
failure to continue sync on port [dec] return_code [hex] ([chars]).
Explanation
Recommended Action
Error Message
disable port [dec] return_code [hex] ([chars]).
Explanation
Recommended Action
Error Message
enable port [dec] return_code [hex] ([chars]).
Explanation
Recommended Action
Error Message
failure to disable force poe mode on [dec] return_code [hex] ([chars]).
Explanation
Recommended Action
Error Message
failure to enable force poe mode on [dec] return_code [hex] ([chars]).
Explanation
Recommended Action
Cisco NX-OS System Messages Reference
2-826
XBAR-5-XBAR_INIT_FAILURE: XBAR [chars] initialization failed [chars]
The supervisor has experienced a fabric initialization failure. The supervisor is going
No action is required.
XBAR-5-XBAR_PORT_CHECK_SYNC_FAIL: Xbar [[dec].[dec]] reported failure
The supervisor has experienced an crossbar setup failure.
No action is required.
XBAR-5-XBAR_PORT_CONTINUE_SYNC_FAIL: Xbar [[dec].[dec]] reported
The supervisor has experienced an crossbar setup failure.
No action is required.
XBAR-5-XBAR_PORT_DISABLE_FAIL: Xbar [[dec].[dec]] reported failure to
The supervisor has experienced an crossbar setup failure.
No action is required.
XBAR-5-XBAR_PORT_ENABLE_FAIL: Xbar [[dec].[dec]] reported failure to
The supervisor has experienced an crossbar setup failure.
No action is required.
XBAR-5-XBAR_PORT_FORCE_POE_DISABLE_FAIL: Xbar [[dec].[dec]] reported
The supervisor has experienced an crossbar setup failure.
No action is required.
XBAR-5-XBAR_PORT_FORCE_POE_ENABLE_FAIL: Xbar [[dec].[dec]] reported
The supervisor has experienced an crossbar setup failure.
No action is required.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03