Dot1X-2; Dot1X-3 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
physical Ethernet interface.
Error Message
[chars], state [chars]: [chars]
DOT1X-4
Error Message
[chars]: [chars] [chars]
Error Message
supported on this port
Error Message
disabled on this port
Error Message
portchannel, MAB is not supported on this port
OL-15994-03
DOT1X-3-NOT_DOT1X_CAPABLE: interface [chars] because it is not a
Explanation Dot1x Authentication can only be enabled on physical Ethernet interfaces.
Enable Dot1x Authentication on physical Ethernet interfaces only.
Recommended Action
DOT1X-3-SM_INIT: Internal error while initializing state machine
An attempt was made to initialize an invalid state machine.
Explanation
Initialize dot1x state machine.
Recommended Action
DOT1X-4-BADEVENT: Event [chars] is invalid for the current state
An attempt was made to post an event to a state machine that is invalid for the current
Explanation
state.
Initialize dot1x state machine.
Recommended Action
DOT1X-4-MAB_DISABLED: Interface [chars] is in Trunk mode, MAB is not
MAB is not supported on Trunk port.
Explanation
To enable MAB make sure that port is not in trunk mode.
Recommended Action
DOT1X-4-MAB_DISABLED: Interface [chars] is in Trunk mode, MAB will be
MAB is not supported on Trunk port.
Explanation
Recommended Action To enable MAB make sure that port is not in trunk mode.
DOT1X-4-MAB_DISABLED_ON_PCM: Interface [chars] is a member of
Explanation MAB is not supported on port channel member port.
To enable MAB make sure that port is not member of port channel.
Recommended Action
Cisco NX-OS System Messages Reference
DOT1X Messages
2-129