Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 793

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
exceeds %d\n Flagging route %s/%d from client \%s\ with nh %s, rnh %s/%d\n as
causing rnh loop
Explanation
which client caused the loop, and take appropriate ation.
Parameters: Max RNH Loop, Prefix, Prefix Length, Client, Next-hop, Prefix, Prefix Length ...
Recommended Action
Error Message
Explanation
Parameters: Function, RPM Error Code ...
Recommended Action
Error Message
Explanation
Parameters: Function, SDWrap Error Code ...
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
id 0x%08x.
Explanation
because of this problem.
Parameters: Problem, Client, Table id ...
Recommended Action
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Error Message
VRF %s for client \%s\
Explanation
be further errors that indicate the failure in more detail. The shown VRF should be reconfigured in
the system. i.e. in global configuration, 'no vrf context <vrf-name>'
Parameters: VRF, Client ...
Recommended Action
OL-15994-03
U6RIB-3-RNH_LOOP_ERROR Format: Number of prefixes forming rnh loop
U6RIB detected a loop between routes installed in the RIB. Check the message to see
Requires operator to intervene.
U6RIB-3-RPM_LIB_ERROR Format: %s %d
An RPM library function returned an error.
No action is required.
U6RIB-3-SDWRAP_LIB_ERROR Format: %s %s
A SDWrap library function returned an error.
No action is required.
U6RIB-3-SEND_TO_ERROR Format: Send to u6rib failed: %s
The calling process was unable to send a message to U6RIB.
Use the 'restart' command to restart the feature and clear this problem.
U6RIB-3-STRUCT_ERROR Format: Structural error: %s, client \%s\, table
A severe data structural error was encountered. The system may run into more errors
Use the 'system switchover' command to switch over to the standby supervisor.
U6RIB-3-TABLE_CREATE_ERROR Format: Failed to create table info for
U6RIB could not create its table data structure for the VRF being created. There may
Requires operator to intervene.
Cisco NX-OS System Messages Reference
U6RIB Messages
2-755