Udld Messages; Udld-3 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Nx-os system messages reference
Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:
Table of Contents

Advertisement

UDLD Messages

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Error Message
Error Message
[chars]: [chars]
UDLD-4
Error Message
tech udld' for detail info.
Error Message
detected
Error Message
Cisco NX-OS System Messages Reference
2-760
UDLD-3-MSG_SEND_FAILURE: failed to send [chars] to sap [dec]: [chars]
The system has failed to send a message.
Explanation
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Recommended Action
Support web site http://www.cisco.com/tac.
UDLD-3-UDLD_INTERNAL_ERROR: UDLD internal error: [chars]
A software sanity check failed in the course of UDLD processing.
Explanation
Recommended Action
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
UDLD-3-UDLD_INTERNAL_IF_ERROR: UDLD internal error, interface
A software sanity check failed in the course of UDLD processing.
Explanation
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Recommended Action
Support web site http://www.cisco.com/tac.
UDLD-4-UDLD_GWRAP_COUNT: UDLD gwrap count is %lu, please log a 'show
UDLD gwrap count reached high level, show tech udld is needed to debug it.
Explanation
Recommended Action
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
UDLD-4-UDLD_PORT_DISABLED: UDLD disabled interface [chars], [chars]
An interface was disabled because UDLD protocol detected the cause indicated on the
Explanation
interface indicated. Cause is likely due to bad interface hardware or cable misconfiguration. User
should investigate.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Recommended Action
Support web site http://www.cisco.com/tac.
UDLD-4-UDLD_PORT_RESET: UDLD reset interface [chars]
A port which had been disabled for UDLD has been reset.
Explanation
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Recommended Action
Support web site http://www.cisco.com/tac.
Chapter 2
System Messages and Recovery Procedures
OL-15994-03

Advertisement

Table of Contents
loading

Table of Contents